PCEngineFans.com - The PC Engine and TurboGrafx-16 Community Forum
NEC TG-16/TE/TurboDuo => TG/PCE Repair/Mod Discussion => Topic started by: mario_pic on May 22, 2015, 02:15:31 PM
-
OK I need some help I got a pce duo I got off eBay pots where messed with and cap job was semi done I got system up and running now my cd drive won't spin I messed gently with the pots and got drive to spin also read once for a bit and froze I need proper pot readings from a working unit I got the list that tells u all the readings from all the legs but there not adding up my question is what's the proper pin to letter diagram what pins are A-B-and C another way I set this type of pot is by probing the ground wire near the cd drive to the top of the pot where u a just it not the legs it's the method used to ajust same pots on a 3d printer servo driver it gives u a good reading can some one probe a good unit and give me the values thanks
-
Welcome to the forums, can't answer your question, but I just wanted to recommend this as your avatar. It will go nicely with the name.
(http://orig01.deviantart.net/2827/f/2014/270/3/8/mario_avatar_by_ojbrony-d80mmqc.html)
-
OK I need some help I got a pce duo I got off eBay pots where messed with and cap job was semi done I got system up and running now my cd drive won't spin I messed gently with the pots and got drive to spin also read once for a bit and froze I need proper pot readings from a working unit I got the list that tells u all the readings from all the legs but there not adding up my question is what's the proper pin to letter diagram what pins are A-B-and C another way I set this type of pot is by probing the ground wire near the cd drive to the top of the pot where u a just it not the legs it's the method used to ajust same pots on a 3d printer servo driver it gives u a good reading can some one probe a good unit and give me the values thanks
First, this is damn near unreadable without a single punctuation in the entire post. Second, read the "REPAIR GUIDE - laser swap and adjustment" sticky in this thread. Welcome to the forum.
-
Mario, punctuation marks are your friends (as Schweaty pointed out).
Welcome :)
-
Welcome to the forums, can't answer your question, but I just wanted to recommend this as your avatar. It will go nicely with the name.
(http://orig01.deviantart.net/2827/f/2014/270/3/8/mario_avatar_by_ojbrony-d80mmqc.html)
How kind of u to save me some time I love it lol
-
Mario, punctuation marks are your friends (as Schweaty pointed out).
Welcome :)
Lol I know voice writer is not the smartest tool lol as long as u get the point it's not a top selling novel lol
-
use the laser adjustment thread
if you have a scope i recently explained that as well (toward end of thread)