PCEngineFans.com - The PC Engine and TurboGrafx-16 Community Forum

NEC TG-16/TE/TurboDuo => TG/PCE Repair/Mod Discussion => Topic started by: Shear_xear on February 12, 2016, 10:11:31 AM

Title: Good spot to mount Obey chip on Turbografx 16
Post by: Shear_xear on February 12, 2016, 10:11:31 AM

Hi everyone!  I was installing my Obey chip in my Turbografx 16 and mounted it on the plastic shield over the Hu Card slot.  When I went to put the shell back on I found it was not going to work as the wires were keeping the shell from "locking" into the motherboard.  Where is a good place to put the chip that won't damage the motherboard?  Thanks!  Mike

Title: Re: Good spot to mount Obey chip on Turbografx 16
Post by: turbokon on February 12, 2016, 03:56:25 PM

Which version obey chip are you using?

Title: Re: Good spot to mount Obey chip on Turbografx 16
Post by: thesteve on February 12, 2016, 03:57:27 PM

there are 2 punch outs on that board, i punch the one by the slot and set the board there

Title: Re: Good spot to mount Obey chip on Turbografx 16
Post by: Shear_xear on February 14, 2016, 04:04:18 AM

Awesome!  I thought those looked like they were unused areas, but punch out?  Thanks so much!! Mike