PCEngineFans.com - The PC Engine and TurboGrafx-16 Community Forum 
		NEC TG-16/TE/TurboDuo => TG/PCE Repair/Mod Discussion => Topic started by: Green on October 11, 2016, 10:36:11 AM
		
			
			- 
				I recently had my Turbo Duo recapped (professionally) because there was no audio. After the recapping there is still no audio and the store I took it to doesn't have the expertise to further troubleshoot an obscure system so here I am.
 I bought a RGB to component board, component couplers, and region unlock board (tiny little thing) too. I was hoping someone here could steer me to someone to further repair and mod for me. Obviously I will pay them.
 
 Thanks!
- 
				I highly recommend TheSteve. The dude can almost fix anything.
			
- 
				Keith Courage is really good as well.
			
- 
				I've had positive experiences with both Keith Courage and mickcris.
			
- 
				How about MNKyDeth? Anyone with experience with him?
			
- 
				How about MNKyDeth? Anyone with experience with him?
 
 
 see here for a review of MNKyDeth's service:
 https://www.youtube.com/watch?v=M_Dbj0oM0rs
- 
				I can do the work too, but my return times are rather long right now.  :( Been really busy with college lately.
 
 I've also installed one of those RGB > Component boards before. Came out really nicely.
- 
				Got the Duo back from MNKyDeth and I highly recommend him. Kept me in the loop with status pictures and was accurate with cost estimate.
 
 Even modded a Monster Cable for me!
 Recap, region mod and component mod. Very happy with it.
- 
				I recently had my Turbo Duo recapped (professionally) because there was no audio. After the recapping there is still no audio and the store I took it to doesn't have the expertise to further troubleshoot an obscure system so here I am.
 I bought a RGB to component board, component couplers, and region unlock board (tiny little thing) too. I was hoping someone here could steer me to someone to further repair and mod for me. Obviously I will pay them.
 
 Thanks!
 
 sounds like the threw holes failed on near the sound caps i usualy clean the threw holes and run a solid wires threw to be shure the sound is always solid its bit of a pain but still able to be done easy