PCEngineFans.com - The PC Engine and TurboGrafx-16 Community Forum

NEC TG-16/TE/TurboDuo => TG/PCE Repair/Mod Discussion => Topic started by: schweaty on December 06, 2016, 10:01:40 AM

Title: Super CDROM2 DC out tip size
Post by: schweaty on December 06, 2016, 10:01:40 AM

Gents,

Can anyone give me the tip size for the DC out on the Super CDROM2?  I need to make a jumper cable.  Thanks!

-dan

edit:  i'm also assuming its center negative since the pc engine and both core grafx's are center neg.  let me know if i'm wrong

Title: Re: Super CDROM2 DC out tip size
Post by: Bloufo on December 06, 2016, 04:12:01 PM

Is this what you're looking for?



(http://i.imgur.com/sU0uCOQ.png)

Title: Re: Super CDROM2 DC out tip size
Post by: schweaty on December 06, 2016, 04:38:35 PM

No.  That does not tell me the tip size for DC output.  The DC out is a different size than the 6.3mm input

Title: Re: Super CDROM2 DC out tip size
Post by: mickcris on December 07, 2016, 01:44:58 AM

99% sure its 4.0mm x 1.7mm and it would be center negative.

Title: Re: Super CDROM2 DC out tip size
Post by: schweaty on December 07, 2016, 02:26:38 AM

Thx!

Title: Re: Super CDROM2 DC out tip size
Post by: schweaty on December 07, 2016, 10:15:55 AM

Quote from: mickcris on December 07, 2016, 01:44:58 AM

99% sure its 4.0mm x 1.7mm and it would be center negative.

i can confirm, this is 100% correct.  thanks again!

Title: Re: Super CDROM2 DC out tip size
Post by: mickcris on December 07, 2016, 01:04:04 PM

Quote from: schweaty on December 07, 2016, 10:15:55 AM

Quote from: mickcris on December 07, 2016, 01:44:58 AM

99% sure its 4.0mm x 1.7mm and it would be center negative.

i can confirm, this is 100% correct.  thanks again!

cool. thanks for confirming.  i added that to the gamesx power supply list