PCEngineFans.com - The PC Engine and TurboGrafx-16 Community Forum
NEC TG-16/TE/TurboDuo => TG/PCE Repair/Mod Discussion => Topic started by: Fabf on May 16, 2017, 01:25:45 AM
-
Hi to all.
I have a DUO without sound.
I made a cap kit but there's no more sound.
I expect that the PCB have been destroyed by acid.
For now I decided to rebuild amp part on a separate board.
I'v found standard sound signals from HU6260 and all is ok but I can't find sound signals from CD.
If someone can help me.
Best regards
-
Look for broken VIAs (small holes in the pcb that connect the upper side with the bottom), mine had no sound because of 2 broken VIAs.
-
You don't have to replace the whole audio amp, PC Engine boards are very repairable. In fact, if you have the original black PC Engine Duo, then your replacement audio amp would have to support both the AV port and the headphone jack, it's just not worth it.
As Abelardo said, look for corroded traces and vias. A via is a little hole where the trace transitions from PCB Side A to Side B. When I fixed the no sound problem on my PC Engine Duo (cap kit didn't restore it), one method I used for finding corroded vias was to hold the board in front of a strong light and see if any vias didn't let any light pass through. That usually means there is corrosion dust built up in the via. The easiest fix is to find the next nearest part of the overall trace and jumper over the corroded via.
Please see my PC Engine Duo repair thread before you go and waste a massive amount of time rebuilding an audio amp needlessly.
http://www.pcenginefx.com/forums/index.php?topic=21529.0
In case you're wondering, the corrosion in my PC Engine Duo knocked out both the AV port audio and both left and right channels at the headphone jack.
-
You're certainely right :wink:
I will remove caps and look for corroded trace or via.
I've ordered some 4558 and I'll change them all.
Then I'll recap the audio part.
I'll let you informed about reparation.
Thank you very much
-
Hi to all.
I have a DUO without sound.
I made a cap kit but there's no more sound.
I expect that the PCB have been destroyed by acid.
For now I decided to rebuild amp part on a separate board.
I'v found standard sound signals from HU6260 and all is ok but I can't find sound signals from CD.
If someone can help me.
Best regards
look at the vias around the power jack section also clean out threw holes in area i find its mostly ground side of the circut that the threw holes fail