PCEngineFans.com - The PC Engine and TurboGrafx-16 Community Forum
NEC TG-16/TE/TurboDuo => TG/PCE Repair/Mod Discussion => Topic started by: bdoi on December 27, 2019, 04:12:08 PM
-
Hi
I tried to replace the capacitor of my LT and I ripped the +pad of the 33µf 10V (surrounded in the pics bellow) #-o
My question: do you know where goes the pad normally , I saw a trace which has been partially taken off (yellow on picture) . Do you know if the +pad was connected to another trace or conponent?
thanks in advance;)
(https://i.postimg.cc/L8GhRdpv/ob-3f352f-pcelt-cap.jpg) (https://postimages.org/)
(https://i.postimg.cc/QM5Cd6ND/20191227-192332.jpg) (https://postimg.cc/p9WR0Jnc)
(https://i.postimg.cc/MTmGyvjr/20191227-1923322.jpg) (https://postimg.cc/bDd8PYgQ)
-
I don't have an LT in front of me to check. Kind of hard to tell from the pics. Hold the board up to a bright light to see if you can follow where the trace goes.
-
I don't have an LT in front of me to check. Kind of hard to tell from the pics. Hold the board up to a bright light to see if you can follow where the trace goes.
Damned! I was counting on your big pcengine knowledge :-\
I will solder the new capacitor on the yellow trace , hope it has been connected only to this trace :pray:
-
I finally managed to make it work ! :D :D
And I also put in a new LCD ;)
(https://i.postimg.cc/VN5qFLZM/20200102-094021.jpg) (https://postimg.cc/JyVHrmL4)
(https://i.postimg.cc/Hk6057zd/20200102-093958-0.jpg) (https://postimg.cc/87rrgcx0)
-
Welcome to 1991.
-
excellent :clap:
-
Mmm, that's one sexy LT. :mrgreen: