PCEngineFans.com - The PC Engine and TurboGrafx-16 Community Forum

NEC PC-Engine/SuperGrafx => PC Engine/SuperGrafx Discussion => Topic started by: stevenhill321 on April 03, 2009, 02:01:42 AM

Title: *****PC Engine LT help needed*********
Post by: stevenhill321 on April 03, 2009, 02:01:42 AM

Can anyone confirm whether their PC Engine LT has a slightly loose lid. You see when I open it up the lid wobbles a bit at its axis. It doesnt fall down and it doesnt hamper gameplay or anything like that and it works fine but I was just wondering if they are all like that or can I tighten it up somehow. I'm a bit hesitant to get the old screwdriver on it. I could live with it but I would like it tighter than it is if possible.

Can anyone help.

If they are all like that then it wont be a problem.

Thanks

Title: Re: *****PC Engine LT help needed*********
Post by: esteban on April 05, 2009, 02:23:56 AM

Quote from: stevenhill321 on April 03, 2009, 02:01:42 AM

Can anyone confirm whether their PC Engine LT has a slightly loose lid. You see when I open it up the lid wobbles a bit at its axis. It doesnt fall down and it doesnt hamper gameplay or anything like that and it works fine but I was just wondering if they are all like that or can I tighten it up somehow. I'm a bit hesitant to get the old screwdriver on it. I could live with it but I would like it tighter than it is if possible.

Can anyone help.

If they are all like that then it wont be a problem.

Thanks

Send it to me and I'll take a look at it.

I haven't had any direct experience with an LT, mind you, but I have seen several blurry pictures in old magazines.

I'll refund the postage once the LT arrives here (New Jersey, USA).

You're welcome.