PCEngineFans.com - The PC Engine and TurboGrafx-16 Community Forum

NEC TG-16/TE/TurboDuo => TG-16/TE/TurboDuo Discussion => Topic started by: Press_Run on June 10, 2009, 12:37:46 PM

Title: A bent box.
Post by: Press_Run on June 10, 2009, 12:37:46 PM

Hey guys!

One of the boxes I've received has a big circular bent outward in the back but have no idea was get it straight.

Any good ideas to flatten this bump?  :?

Title: Re: A bent box.
Post by: guyjin on June 10, 2009, 12:42:15 PM

Flatten it out, if you can, and stack your encyclopedia (or as many big books you can find) on top of it for a few days.

Title: Re: A bent box.
Post by: Turbo D on June 10, 2009, 09:51:52 PM

lol, sounds like my Legend of Hero Tonma box.:roll: I believe it mutated as an after-affect of being sealed for too long (not by me of course!)

Title: Re: A bent box.
Post by: Necromancer on June 11, 2009, 02:54:16 AM

Put it between a couple sheets of heavy weight paper and iron that sucker.  Make sure you don't crank the heat on the iron though, or you'll eff it up but good.