PCEngineFans.com - The PC Engine and TurboGrafx-16 Community Forum 
		NEC TG-16/TE/TurboDuo => TG-16/TE/TurboDuo Sales & Trades => Topic started by: _joshuaTurbo on March 09, 2010, 07:18:46 AM
		
			
			- 
				Looking for Turbografx RF adapter, AC adapter, and controllers.
Anyone know where I can get a multitap that can be used to change pcengine controllers inputs for use on an american turbo?
Thanks in advance for any sales or advice
Joshua
			 
			
			- 
				
Anyone know where I can get a multitap that can be used to change pcengine controllers inputs for use on an american turbo?
TZD did sell 'reverse' taps for such a purpose, but good luck finding one.  You could always make your own by following nat's handy dandy guide for swapping a pad cable from a Turbo controller into a DuoTap/MultiTap.
			 
			
			- 
				I could make ya one.  I have a spare tap and a spare TG-16 pad cable... which has the added benefit of the 3ft length instead of the usual tap's short cord.
It'd cost ya $30 + $5 shipping.  PM me if interested.
			 
			
			- 
				
I could make ya one.  I have a spare tap and a spare TG-16 pad cable... which has the added benefit of the 3ft length instead of the usual tap's short cord.
It'd cost ya $30 + $5 shipping.  PM me if interested.
Thanks man, I will have to get back to you on that one!
For now I'll just go the TurboPad route.
			 
			
			- 
				I got all of these for I hope a steal.
Used AC and RF adapter for $12 shipped
and 2 sealed TurboPads for $20
I'm locky this thread....