« previous next »
Pages: [1]

Author Topic: coregrafx expansion port  (Read 213 times)

neofx

  • Newbie
  • *
  • Posts: 6
coregrafx expansion port
« on: April 03, 2010, 09:17:55 PM »
Hi,

I am looking for the male connector for the pcengine expansion port, since I would like to make a jamma adapter for it without having
to open the console. For know I was unable to find any references on the web.

Any information welcome !

thank you
Logged

Charlie

  • Full Member
  • ***
  • Posts: 247
Re: coregrafx expansion port
« Reply #1 on: April 05, 2010, 11:12:25 AM »
Is that the same as the 3x23 connector on the back of the TG16?  Got mine from Digikey..it was a 3x? that was too long, so I cut it.  Get the right angle connector, cut it to fit....plugs right into a PCB (with .1x.1 centers...either a perf board, or a homebrew) and holds it in place very nicely.

Charlie
Logged

neofx

  • Newbie
  • *
  • Posts: 6
Re: coregrafx expansion port
« Reply #2 on: April 06, 2010, 11:35:30 PM »
Thank you very much for the information  :wink:
Logged

Tupin

  • Jr. Member
  • **
  • Posts: 50
Re: coregrafx expansion port
« Reply #3 on: April 28, 2010, 11:18:31 AM »
Where else can you get these connectors, what are they called? Wouldn't a female connector plug into the slot directly?
Logged

masaruh

  • Newbie
  • *
  • Posts: 6
Re: coregrafx expansion port
« Reply #4 on: April 28, 2010, 12:40:29 PM »
They are called Euro Connectors over here at least( http://www.ornatus.se/index.php?option=com_content&task=view&id=55&Itemid=40&lang=english ), but the PC Engine version has a non-standard lenght so you'll most likely have to buy a longer and cut it to the correct lenght. The PCE connector is also fairly deep which might pose a problem.
Logged
Pages: [1]
« previous next »